Go to maincontent

Step by step guide

Evolution: Replace hose & swivel

Swivel: 902-101-01. Hose: 11-120-405

Learn how to easily replace the hose & swivel on your Evolution pressure washer with this step-by-step guide. All you need are Torx 25 and one flathead screwdriver, or similar tools. Safety first! To prevent any accidents, ensure that your pressure washer is turned off and unplugged from its power source

1. Disconnect /replace hose

a)Pull the hose completely until all the hose is out of the reel, allowing you to see the swivel.


b)Use a flathead screwdriver or similar to remove the U-pin.


c)Pull out the hose.


d)If you want to replace a new hose: Put the new hose into the quick connector and reinstall the u-pin: Insert the u-pin into the slot and push it all the way into the quick connector. If the U-pin is difficult to insert, gently tap it with a small hammer or a similar tool.

If the new hose have a Female Coupler please see article: AVA Steel-Reinforced Hose with Female Coupling

2. Disconnect the internal hose

a)Use a flathead screwdriver or similar, to tilt out the U-pin.


b)Pull the internal house out of the reel.

3. Disassembly swivel

a)Use a flathead screwdriver or similar uninstall the e-clip.


b)Dismount the swivel.

4. Install new swivel

a)Assemble swivel.


b)Secure swivel with e-clip.


c)Install internal hose and secure it with u-pin.


d)install hose into swivel and secure it with u-pin.